STRATUS-G29 3D printed model rocket.

Description

Welcome!
!NOTICE! These are the last of the fully 3D printed versions left!
Thank you for checking out
ShelTech's
most ambitious 3D printed model rocket to date!
The Stratus-G29 is a large rocket utilizing either a E, F or G series motor.
(29mm diameter motors)
multiple years of research and development have gone into the design and printing of this massive model rocket just like its smaller version the Ravix-D24.
-------------------------------------------------------------------------------------------------------------------------------------------------------
SPECS:
525.10 x112.17 x112.17mm
20.6
inches
tall.
4.4 inches fin tip to fin tip.
31.0mm body tube
diameter
with inner-protruding "snug-fit" motor mounts to
accommodate
29mm motors.
Altitude is dependent on motor size and type/class!
We suggest either E, F, or G size motors for best results.
-----------------------------------------------------------------------------------
Material:
PLA
PLA
(
plastic or polylactic acid is a vegetable-based, NON_TOXIC plastic
material
, which commonly uses cornstarch as a raw
material
.
PLA
is a fully biodegradable thermoplastic polymer consisting of renewable raw
materials)
Total
materials
used = 222g
Total weight of the rocket with NO motor = 6.3oz
--------------------------------------------------------------------------------------
Speed:
Incredibly smooth and slick surfaces allows this rocket to effortlessly stream through the air.
Launch-lugs:
Launch-rod guides allow for a wide variety of different diameter launch rods.
You will have to make/buy/attach them yourself!
Altitude:
Altitude will be different depending on the motor type you choose. 1500+ Ft. is achievable.
--------------------------------------------------------------------------------------------------------------------------------------------------------
Smaller
diameter motors will require retainers for proper fitment.
Not only is this our largest rocket but it's also the most time consuming to print.
-
Total print time = 2 days, 3 hours, 11 minutes and 18 seconds using SUPER-quality settings to
achieve
a near perfect print.
Sanding and painting are required for a custom look/finish.
-----------------------------------------------------------------------------------------------------------------------------------------------------
!
FREE
SHIPPING
to
ALL STATES
!
-----------------------------------------------------------------------------------------------------------------------------------------------------
!We DO NOT provide a recovery system with our rockets!
!Remember to always fly in a safe and designated area with a friend!
!WE ARE NOT
responsible
for ANY
negligent use
of our rockets!
Thank you for checking out ShelTech LLC!